FixVault
Home › Audi › 1989 › 80 Base, Standard › Repair and Diagnosis › Engine Mechanical › Mechanical › 2.0L 4-CYL › Engine Specifications

Engine Specifications

GENERAL ENGINE SPECIFICATIONS

Application In. (mm)
Displacement
Cubic Inches 121
Liters 2.0
Fuel System CIS Motronic
HP @ RPM 108 @ 5300
Torque Ft. @ RPM 121 @ 3200
Compression Ratio 10.4:1
Bore 3.25 (82.6)
Stroke 3.65 (92.7)
PISTONS, PINS & RINGS SPECIFICATIONS

Application In. (mm)
Piston Clearance .0016 Maximum (.041)
Piston Diameter 3.247 (82.48)
Pins
Diameter Not Supplied
Piston Fit Interference
Rod Fit Interference
Ring End Gap
Standard .012-.018 (.30-46)
Service Limit .04 (1.0)
Ring Side Clearance
Standard .0008-.0020 (.020-.050)
Service Limit .006 (.15)
CRANKSHAFT MAIN & CONNECTING ROD BEARINGS SPECIFICATIONS

Application In. (mm)
Crankshaft End Play .003-.007 (.07-.17)
Crankshaft Runout .001 (.03)
Crankshaft Journal Taper .001 (.03)
Crankshaft Journal Out-Of-Round .001 (.03)
Main Bearings
Journal Diameter 2.1268-2.1276 (54.021-54.041)
Oil Clearance .001-.003 (.03-.07)
Connecting Rod Bearings
Journal Diameter 1.8827-1.8835 (47.821-47.841)
Oil Clearance .001-.005 (.03-.09)
Maximum Connecting Rod Side Play .015 (.38)
CYLINDER HEAD SPECIFICATIONS

Application In. (mm)
Maximum Cylinder Head Warp .004 (.10)
Seat Angle 45°
Valve Seat Maximum Runout n/a
Valve Seat Width
Intake .079 (2.01)
Exhaust .094 (2.40)
Seat Bore Diameter n/a
Valve Stem Oil Clearance
Intake .039 (.99)
Exhaust .051 (.40)
Valve Guide Inside Diameter .315 (8.00)
Valve Guide Bore n/a
CYLINDER BLOCK SPECIFICATIONS

Application In. (mm)
Maximum Block Warp n/a
Cylinder Bore
Standard Diameter 3.189 (81.01)
1st Oversize 3.199 (81.26)
2nd Oversize 3.209 (81.51)
Maximum Taper n/a
Maximum Out-of-Round n/a
VALVES & VALVE SPRINGS SPECIFICATIONS

Application In. (mm)
Intake
Head Diameter 1.575 (40.00)
Standard Valve Length 3.583 (91.01)
Minimum Stem Diameter .314 (7.97)
Valve Springs (1)
Minimum Margin (2)
Exhaust
Head Diameter 1.300 (33.00)
Minimum Stem Diameter .314 (7.95)
Standard Valve Length 3.574 (90.78)
Valve Springs (1)
Minimum Margin (2)
(1) No information is supplied by manufacturer for any valve spring specifications.
(2) DO NOT machine valves. Hand lap only.
CAMSHAFT SPECIFICATIONS

Application In. (mm)
Oil Clearance .004 (.10)
Crankshaft End Play .006 (.15)
About FixVault