Full Throttle Switch
- Connect voltmeter between terminal No. 3 of throttle switch and ground. Turn ignition on. Voltmeter should read battery voltage. Fasten pointer for Protractor (3084) to adjuster for accelerator cable (use a rubber band). See Figure .
- Screw protractor onto throttle shaft and unscrew throttle shaft nut (if necessary). Push throttle lever to full open (at stop limit). Zero pointer plus disc.
- Slowly open throttle to full position. Ensure voltage drops near zero when throttle opens 6-14 degrees before contacting full throttle stop. If not, adjust or replace full throttle switch.