Rpm Sensor Bracket

WARNING: This page is about a different car, the 1993 Audi 90 and 1993 Audi 100. However, it is still accessible from the selected car via links, so may be relevant.

Remove Crankshaft Position sensor (CKP). Position crankshaft at TDC. See Fig 1 . Screw Crankshaft Positioner (V.A.G. 3242) into sensor hole. Hole in crankshaft can be seen or felt through sensor hole in block. See Fig 2 and Fig 3 .
Remove heat shield. Remove Engine Speed (RPM) sensor and loosen RPM sensor bracket.
Insert RPM Sensor Gauge (V.A.G. 3308) until locked into gear tooth. Push bracket within slots to ensure sensor gauge is locked into gear tooth. Retighten bracket and reinstall RPM sensor.

Fig 1: Locating TDC Marks

Courtesy of AUDI OF AMERICA, INC.

Fig 2: Positioning Crankshaft

Courtesy of AUDI OF AMERICA, INC.

Fig 3: Positioning Crankshaft

Courtesy of AUDI OF AMERICA, INC.