FixVault
Home › Audi › 1992 › 100 CS, 2.8 K, Standard › Repair and Diagnosis › Engine Performance › System › Engine Controls - System/Component Tests › Engine Sensors & Switches › Hall Sensor (Camshaft Position Sensor)

Hall Sensor (Camshaft Position Sensor)

  1. Disconnect hall sensor connector. Refer to the ELECTRICAL COMPONENT LOCATIONS  table. Connect Test Box (VAG 1598) to ECU with Adaptor Cable (VAG 1598/11). Connect LED Tester (1115) between test box terminals No. 8 and 46. Operate starter for several seconds.
  2. If LED flashes at each second engine revolution, go to next step. If LED does not flash at each second engine revolution, check for faulty wiring. If wiring is okay, go to next step.
  3. Turn ignition on. Check voltage between test box terminals No. 7 and 45. If 9 volts minimum is not present, replace ECU. If 9 volts minimum is present, check voltage between test box terminals No. 8 and 45. If 4 volts minimum is not present, replace ECU. If 4 volts minimum is present, replace hall sender.
About FixVault