Repair Instructions: Mounts
- Install needle bearings with the lettering on the bearing (the side with thicker metal) facing the drift.
- Insert bearing with transmission oil or ATF, depending on installation location.
- Tapered roller bearings for output shaft and differential in rear final drive are low-friction bearings. Do not grease new tapered roller bearings additionally for friction torque measurement. The bearings are already greased with a special oil from the factory for this reason.
- Do not interchange inner and outer bearing races with those from other bearings of the same size.
- Tapered roller bearings are allocated to the date of transmission manufacture and code letters.
- Always replace tapered roller bearings on one shaft together and use new bearings from the same manufacturer.
- Heat tapered roller bearing inner races to approx. 100° C before installing. Press in to stop so that there is no axial play.