Servotronic, assembly overview: Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
The following list pertains to Fig 1.
- Power steering gear with tie rods
- Assembly Overview, see POWER STEERING GEAR, ASSEMBLY OVERVIEW
- Connector for servotronic
- Relay carrier, 13-pin
- Located under trim in driver's footwell
See appropriate System Wiring Diagrams article.
- Relay for servotronic control module - J236- (position 13)
- Checking voltage supply, see SERVOTRONIC, CHECKING VOLTAGE SUPPLY
- Checking speed signal, see SPEED SIGNAL, CHECKING
- Located under trim in driver's footwell
- Socket-head bolt, 3 Nm
- 2.5 mm
NOTE: Do not open Torx bolts! - Servotronic solenoid valve - N119-
- Steering gear must be removed to replace servotronic valve.
- Checking, see SERVOTRONIC VALVE, CHECKING
NOTE: DO NOT open Torx bolts! - Seal
- Always replace
- Seal
- Always replace
- Sieve
- Always replace