Work step 3: Adapt throttle valve control module to Engine Control Module (ECM)
- Ignition switched on
| Rapid data transfer HELP Select function XX |
Indicated on display:
- Press buttons -0- and -4- to select "Initiate basic setting" and press -Q- button to confirm input.
| System in Basic Setting Q Input display group number XXX |
Indicated on display:
- Press buttons -0-, -6- and -0- to select "display group number 060" and press -Q- button to confirm input.
| System in Basic Setting 60 " 1 2 3 4 |
Indicated on display:
- Check specified values in display fields 3 and 4
| Display fields | ||||
| 1 | 2 | 3 | 4 | |
| Display group 060: Adaptation of throttle valve control module | ||||
| Display | xx % | xx % | x | --- |
| Indicated | Throttle valve angle (angle sensor 1) |
Throttle valve angle (angle sensor 2) |
Adaptation step counter | Adaptation condition |
| Functional range | 0 to 100 % | 0 to 100 % | 0 to 8 | ADP in progress ADP OK ADP ERROR |
| Specified value | 3 to 93 % | 97 to 3 % | 8 | ADP OK |
| Notes | During adaptation, the adaptation step counter must reach the number 8. (Some numbers may be skipped). | If "ADP ERROR." is displayed: Check DTC memory. Refer to
Engine should run at idle . If specified value is not obtained: Refer to Throttle valve control module -J338-, adapting . |
||
If specified value "ADP OK" is obtained:
- Press -C- button.