Section 6 (Overhaul - A/T 01V)
WARNING: This page is about a different variant/trim than selected.
- Identification
- Description & Operation
- Lubrication & Adjustments
- On-Vehicle Service
- Code Letters, Engine/Transmission Applications, Ratios, Equipment
- General Repair Instructions
- Torque Converter
- Automatic Transmission - Controls, Housing
- Automatic Transmission, Overhaul
- Automatic Transmission - Gears, Hydraulic Controls
- Final Drive, Differential
- Rear Final Drive, Removing And Installing
- Differential (Rear), Removing & Installing
- Differential, Disassembling & Assembling
- Special Tools & Equipment
- Differential, Disassembling & Assembling
- Driving Small Tapered Roller Bearing Outer Race Out Of Housing
- Pressing Tapered Roller Bearing Outer Race Into Housing
- Pulling Off Tapered Roller Bearing Inner Race
- Pressing On Tapered Roller Bearing Inner Race
- Pulling Off Double Tapered Roller Bearing Inner Race
- Pressing On Double Tapered Roller Bearing Inner Race
- Driving Out Large Tapered Roller Bearing Outer Race From Cover
- Pressing In Large Tapered Roller Bearing Outer Race Into Cover
- Driving Out Ring Gear From Housing
- Installing Ring Gear
- Install Differential Bevel Gears
- Differential Bevel Gears, Adjusting
- Drive Pinion, Removing & Installing, Disassembling & Assembling
- Special Tools & Equipment
- Removing, Installing, Disassembling & Assembling
- Notes
- Removing Drive Pinion Nut
- Pull Off Driveshaft Flange From Drive Pinion
- Pulling Out Seal For Driveshaft Flange
- Pressing Out Drive Pinion From Small Tapered Roller Bearing Inner Race
- Pulling Out Tapered Roller Bearing Outer Race
- Driving Out Double Tapered Roller Bearing Outer Race
- Pressing Off Large Tapered Roller Bearing Inner Race From Drive Pinion
- Pressing Large Tapered Roller Bearing Inner Race Onto Drive Pinion
- Pressing In Double Tapered Roller Bearing Outer Race
- Pressing In Tapered Roller Bearing Outer Race
- Pressing On Tapered Roller Bearing Inner Race
- Replacing O-Ring
- Driving In Seal For Driveshaft Flange
- Installing Flange
- Tightening Drive Pinion Nut And Adjusting Friction Torque
- Measuring Friction Torque
- Securing Drive Pinion Nut
- Measuring Driveshaft Radial Runout
- Drive Pinion & Ring Gear, Adjusting
- Shim Location
- Drive Pinion, Adjusting
- Ring Gear, Adjusting