Work procedure

Select the desired measured value according to the PID (Parameter Identification), e.g. "PID 05 - Coolant temperature", via the following table.

NOTE:

Specified values assigned to the measuring values are found in the corresponding component- and function tests.
Measuring values of Engine Control Module (ECM) are displayed under "10 - Engine electronics" and measuring values of Transmission Control Module (TCM) are displayed under "1A - Transmission electronics".

MODE 1: PID MEASURING VALUES

PID⁽¹⁾

Display measuring values

01:

Monitoring status since erasing DTC memory

03:

Condition of the fuel system

04:

Calculated load condition value

05:

Coolant temperature

06:

Short time gasoline-air ratio bank 1

07:

Gasoline-air ratio bank 1

12:

Engine rotations per minute (RPM)

13:

Vehicle speed

14:

Valve timing adjustment at 1. cyl. to "advance"

15:

Intake Air Temperature (IAT)

16:

Air flow quantity at Mass Air Flow (MAF) sensor

17:

Throttle valve position (absolute)

18:

Availability status of secondary air

19:

Available oxygen B1-S1, B1-S2

20:

Sensor voltage Bank 1 - sensor 1

21:

Sensor voltage Bank 1 - sensor 2

28:

OBD-requirement for which this vehicle is designed -OBD II-CARB and OBD-EPA

52:

Current output of oxygen sensor signal value Bank 1 -sensor 1

⁽¹⁾	PIDs that are not relevant are not listed.