Tire Pressure Monitoring Control Module

Removing

NOTE:

The tire pressure monitoring control module -J502- is located under the glove compartment.

Before removing control module, read out code using Guided Fault Finding in "Replace control module" function.

-- Remove the glove compartment. Refer to Removal and Installation .

-- Press the locking mechanism -arrow- upward and pull the tire pressure monitoring system control module -1- out of the retainer slightly.

Fig 1: Identifying Tire Pressure Monitoring Control Module -1- And Connector -2-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- and remove the tire pressure monitoring control module -1- from the retainer.

Installing

Install in reverse order of removal.

-- If tire pressure monitoring control module is replaced, system must be coded. Refer to TIRE PRESSURE MONITORING SYSTEM USAGE, DIRECT SYSTEM .