Ignition Key Lock, Check Function
NOTE:
There are no mechanical ignition key locks with cable, but rather an electrical ignition key lock.
Procedure
-- Turn on the ignition.
-- Press the brake pedal and hold it down.
- It must be possible to move the selector lever out of P without getting stuck when the locking button in the selector lever handle is pressed.
-- Turn off the ignition.
- It should not be possible to remove the ignition key when the selector lever is in any other position than P.
-- Move the selector lever into P.
-- Remove ignition key.
- It should be possible to remove the key only when the selector lever is in P.
- It is not possible to move the selector lever out of P when both the locking button and the brake pedal are pressed.
If the ignition key removal lock does not work as described:
- Refer to SELECTOR LEVER CABLE, CHECK AND ADJUST IF NECESSARY .
- Check the vehicle through Guided Fault Finding refer to vehicle tester.