Rearview Camera, Calibrating

-- Set-up requirements. Refer to Calibration Tool .

-- Connect the Vehicle Diagnostic Tester.

:VAS6350/1  Installing

-- Check the dimension of the holes.

-- Equip the :VAS6350/1  appropriately. Use spacer pieces.

-- To do so, secure three wheel bolt adapters in the hole circle to each :VAS6350/1  .

-- Place the paddle on both :VAS6350/1  and secure them using a clamping screw.

-- Place the :VAS6350/1  onto the wheel bolts on the rear wheels.

The :VAS6350/1  are positioned by the "O rings" in the adapters and held in place.

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the paddle with aid of lock bolts so that they move freely just above the floor. Make sure that the paddle is easily accessible.

-- Install and align the :VAS6350  . Refer to Calibration Tool .

Distance Measurement 

-- Switch on the :VAS6350/2  .

The following display appears.

Courtesy of AUDI OF AMERICA, LLC

The display shows how to stop the :VAS6350/2  . Press the corresponding button.

Courtesy of AUDI OF AMERICA, LLC

1. Attach with front edge
2. Attach with rear edge

-- Hold the :VAS6350/2  -2- flush in the bracket on one side of the calibration board (attach with rear edge). The :VAS6350/2  -2- must sit securely on the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Press the measuring button briefly.

The laser turns on.

-- The laser beam from the :VAS6350/2  -2- must hit the lower, enlarged section of the paddle -1-.

If this is not the case, correct the paddles accordingly via clamping screws on the :VAS6350/1  .

-- Use one hand to secure the :VAS6350/2  in the bracket on the :VAS6350  while the laser beam is visible on the paddle.

-- Then press the measuring button for distance measurement briefly.

-- Write down the value.

-- Repeat this measurement on the other side of the :VAS6350  in the same way for the rear wheel.

The distance value must be the same on both sides.

If values are not identical:

-- Align the :VAS6350  long enough so that both sides are identical.

Pay attention when aligning the :VAS6350  , that the :VAS6350/3  from the :VAS6350  strikes the center of the Audi rings and the indicator of the level remains centered. Adjust if necessary.

Dimension Measurement -H-

-- Measure the height of the :VAS6350  , dimension -H- (top edge platform - floor).

Courtesy of AUDI OF AMERICA, LLC

Make sure the :VAS6350/2  is adjusted correctly (attach with front edge).

The display shows how to stop the :VAS6350/2  . Press the corresponding button.

Courtesy of AUDI OF AMERICA, LLC

1. Attach with front edge
2. Attach with rear edge

Enter the height and distance dimensions into the Vehicle Diagnostic Tester in "millimeters".

Performing Calibration 

Vehicle Diagnostic Tester is attached.

-- Select the Diagnostic  mode and start the diagnostics.

-- Select the tab Test Plan  .

-- Select Select Individual Tests  and choose the following sequence.

• Body
• Electrical Equipment
• 01 - OBD-capable systems
• 6C - rearview camera system/J772
• 6C - rearview camera system control module, functions
• 6C - Calibration, (Repair Group 91)

The Vehicle Diagnostic Tester continues with the calibrating procedure from here on.