A/C Compressor Input Shaft, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2018 Audi A7 Quattro, 2017 Audi S7, and 2017 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Installation is done is reverse order, observe the following:

NOTE:

Replace the damaged boot.

Secure all hose connections with hose clamps used in series production.

-- Check the input shaft -B-. The splines must show no traces of wear and must be seated free of play in the drive wheel splines -C-.

-- Prior to installation, grease the splines of input shaft -B- for example with Lubricating Grease:G 000 100 .

-- Insert the input shaft -B- before installing A/C compressor and slide it into the drive wheel -C- all the way to the stop.

-- Secure the boot -A- to the flange with the hose clamps to avoid slipping.