Service Interval Display, Resetting Service Event

WARNING: This page is about a different car, the 2021 Audi e-tron Quattro and 2019 Audi e-tron Quattro. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Risk of injury due to unintended engine start on high-voltage vehicles!

Pay attention to the high-voltage system warning messages:
For procedures where the ignition must be switched off.

NOTE:

The Full Pre-Delivery Inspection test program may also be performed as part of the pre-delivery inspection.

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Deselect "Working with Guided Fault Finding" by removing v and pressing Accept .

-- Switch to the "Special functions" tab.

-- Service Interval, Resetting with ODIS (select the corresponding service).

-- Start the program using Perform test... .

-- Continue the program sequence.