Section 17 (Rear Final Drive 02D)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2006 Audi TT, 2005 Audi TT, 2004 Audi TT, 2003 Audi TT, and 2002 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
- 00 - General, Technical Data
- 39 - Final drive, Differential
- Drive shaft, servicing, overview
- Drive shaft, removing
- Vehicle Diagnosis, Testing and Information System VAS 5051B , connecting and selecting function
- Electrical/electronic components and installed locations
- Haldex clutch, electrical test
- Rear final drive, removing
- Gear oil in rear final drive, checking
- Oil level in Haldex clutch, checking
- Sealing ring for flange/drive shaft on rear final drive (final drive removed), replacing
- Flange shaft sealing ring (final drive installed), replacing
- O-rings for cover / rear axle housing (final drive installed), replacing
- O-ring for drive pinion housing / Haldex clutch (final drive removed), replacing
- Rear final drive, disassembling and assembling, overview
- Rear final drive, disassembling and assembling, overview
- Haldex clutch and clutch discs cover, removing and installing
- Drive pinion housing, removing and installing
- Differential and head bevel gear / input shaft, removing and installing
- Cover for Haldex clutch from disc housing, removing and installing
- Assembly sequence - Haldex clutch cover with disc housing, drive pinion housing/shaft bevel gear disc pack, head bevel gear/input shaft and differential, removing
- Differential, assembly overview
- Shaft bevel gear bearing, servicing, overview
- Head bevel gear/input shaft bearing, assembly overview
- Shaft and head bevel gear (gear set), adjusting
- General notes
- Gear sets, adjustments and markings
- Location of shims
- Adjustment overview (rear final drive)
- Recommended sequence for adjusting gear set
- Shaft bevel gear, adjusting
- Head bevel gear, adjusting
- Notes
- Preload of tapered roller bearing for differential, setting
- Example:
- Determining thickness of adjustment shim S 1
- Torsional backlash, measuring
- Determining shim thickness S 2
- Available adjustment shims for S 2
- Determining shim thickness S 1
- Available adjustment shims for S 1
- Performing control measurement - measuring backlash