ABS Control Module -J104- and ABS Hydraulic Unit -N55-
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S8, 2018 Audi A8 Quattro, 2017 Audi S8, 2017 Audi A8 Quattro, and 2016 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 4.5 Nm
- ABS Control Module -J104-
- Information for exchanging control modules. Refer to CONTROL MODULE, SEPARATING FROM HYDRAULIC UNIT .
- Control module, replacing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .
- Wiring Harness Connector
- Do not disconnect connector (47 pin) before successfully completing self-diagnosis. Switch ignition off before separating connector
- ABS Hydraulic Unit -N55-
- Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .CAUTION:
There is a risk of destroying the hydraulic unit.
- The pump motor may not be separated from the ABS Hydraulic Unit -N55-.
- Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .