Control Module, Separating From Hydraulic Unit: Procedure

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2020 Audi S4, 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, and 2019 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the hydraulic control unit. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .

CAUTION:

- Discharge electrostatic charge: touch the electro-static discharge work surface

- Protect the inner control module from moisture and dirt.

-- Place the hydraulic unit with the control module on the ESD Work Surface:VAS6613 .

The control module -2- faces upward and the hydraulic unit -4- with the pump motor and connector -3- faces down.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- and dispose of them.

-- Carefully remove the control module vertically upward without tilting.

Blowing the control module or hydraulic unit out with compressed air is not permitted.
The valve bodies inside the hydraulic unit must not be damaged or bent.

-- Cover the open hydraulic unit with a lint-free cloth.

-- Check the hydraulic unit sealing surface, and if necessary, clean with mineral spirits and a lint-free cloth.

-- A damaged sealing surface must not be mechanically reworked. A hydraulic unit with a damaged sealing surface must be replaced.

CAUTION:

- Do not remove or lift the seal.