Steering Column, Removing And Installing: Installing: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
- If the steering column on a vehicle with the steering locking system was replaced, use the bolt installed in the new steering column for the Electronic Steering Column Lock Control Module -J764-.
NOTE:
If the steering column was replaced, use the bolt installed in the new steering column for the Electronic Steering Column Lock Control Module -J764-.
Clean the threaded hole (for example, using a thread tap) before installing the new bolt -2-.
Applies to Vehicles with the Steering Lock Lock-Up System
-- After connecting the connector, -1- make sure the wiring harness is secured by the clip -2-.
-- If the steering column needs to be adjusted, be careful not to pinch the wiring harness -3- for the Electronic Steering Column Lock Control Module -J764- -1- and make sure it does not come in contact with any sharp edges.