Control Position, Programming

• The lower transverse link has been removed and reinstalled or replaced
• The subframe was replaced,
• Installation work has been performed on the level control system sensor,
• The level control system sensor has been replaced,
• The level control system sensor coupling rod threaded connection was loosened at the lower transverse link.
• The Level Control System Control Module -J197- was replaced.

Requirements 

• The vehicle must be standing on an even surface.
• The vehicle may not be loaded.

The Programing and Control Position Is Performed Using the Vehicle Diagnostic Tester:

VASPC 

Connect Vehicle Diagnostic Tester.

-- Select Guided Functions  mode.

-- Select the "34 - Level Control System Control Module" address.

-- Select "J197 - reprogram control position" and follow the instructions on the screen.

ODIS - Offboard Diagnostic Information System 

Connect Vehicle Diagnostic Tester.

-- Select Diagnostic  operating mode and start diagnostics.

-- Select the Control Module  tab.

-- Select the "34 - Level Control System Control Module" address.

-- Select "J197 - reprogram control position" and follow the instructions on the screen.