7.3.1 Image Processing Control Module -J851-, Removing and Installing
NOTE:
If replacing the control module, select the "Replace control module" function for the corresponding control module on the Vehicle Diagnostic Tester.
Removing
- Remove the right front sill panel. Refer to Body Interior; Rep. Gr. 70; Vehicle Interior Trim Panels; Sill Panel (Removing and Installing.)
- Remove the floor mat.
- Loosen the front passenger seat and push rearward with the wires still attached. Refer to Body Interior; Rep. Gr. 72; Front Seat; Front Seat (Removing and Installing.)
- Disengage the carpet and push aside.
- Remove the nuts -arrows-.
- Remove the bolts -1 to 4- and remove the bracket -5- from the image processing control module.
- Disconnect the connector -2- and the antenna wire -1-.
- Remove the image processing control module -3- from the front passenger footwell.
Installing
Install in reverse order of removal.
Tightening Specifications