Rearview Camera -R189-, CALIBRATING

-- Establish the requirements Calibration Unit => Calibration Requirements .

-- Connect the Vehicle Diagnostic Tester.

:VAS6350/1  installing:

-- Check the dimension of the holes.

-- Equip the :VAS6350/1  appropriately. Use spacer pieces.

-- To do so, secure three wheel bolt adapters in the hole circle to each :VAS6350/1  .

-- Place the paddle on both :VAS6350/1  and secure them using a clamping screw.

-- Place the :VAS6350/1  onto the wheel bolts on the rear wheels.

The :VAS6350/1  are positioned by the "O-rings" in the adapters and secured.

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the paddles with aid of lock bolts so that they move freely just above the floor. Check the paddles for ease of movement.

-- Install and align the :VAS6350A  . Refer to Calibration Unit .

Distance measurement: 

-- Switch on the :VAS6350/2  .

Courtesy of AUDI OF AMERICA, LLC

The display shows how to stop the :VAS6350/2  . Press the corresponding button.

Courtesy of AUDI OF AMERICA, LLC

1. Attach with front edge
2. Attach with rear edge

-- Hold the :VAS6350/2  -2- flush in the bracket on one side of the calibration board (attach with rear edge). The :VAS6350/2  -2- must sit securely on the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Press the measuring button briefly.

The laser switches on.

-- Make sure that laser beam from :VAS6350/2  -2- hits lower, enlarged part of paddle -1-.

If this is not the case, the paddles must be corrected accordingly via clamping screws on the :VAS6350/1  .

-- Use one hand to secure the :VAS6350/2  in the bracket on the :VAS6350  while the laser beam is visible on the paddle.

-- Then press the measurement button for the distance measurement briefly.

-- Write down the value.

-- Repeat this measurement on the other side of the :VAS6350  in the same way for the rear wheel.

The distance value must be the same on both sides.

If values are not identical:

-- Align the :VAS6350A  long enough so that both sides are identical.

Pay attention when aligning the :VAS6350  , that the :VAS6350/3  from the :VAS6350  strikes the center of the Audi rings and the indicator of the level remains centered. Adjust if necessary.

Measurement -dimension H- :

-- Measure the height of the :VAS6350  , -dimension H- (top edge platform - floor).

Courtesy of AUDI OF AMERICA, LLC

Make sure the :VAS6350/2  is adjusted correctly (attach with front edge).

The display shows how to stop the :VAS6350/2  . Press the corresponding button.

Courtesy of AUDI OF AMERICA, LLC

1. Attach with front edge
2. Attach with rear edge

Enter the height and distance dimensions into the Vehicle Diagnostic Tester in "millimeters".

Calibrating 

The Vehicle Diagnostic Tester is connected.

-- Select the Diagnostic  mode and start the diagnosis.

-- Select the Test plan  tab.

-- Press the Select individual tests  button and select the following one after the other:

• Body
• Electrical Equipment
• 01 - OBD-capable systems
• 6C - rearview camera system/J772
• 6C - Rearview camera system control module, functions
• 6C - Calibration, (Repair Group 91)

From here, the Vehicle Diagnostic Tester advances the calibration procedure forward.