Rear Peripheral Camera -R246-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical consumers and remove the ignition key.

The Rear Peripheral Camera -R246- has a trailing cable pig tail. The vehicle wiring harness couplings are located in the rear lid.

-- Remove the lower rear lid trim panel. Refer to LOWER REAR LID TRIM PANEL, REMOVING AND INSTALLING .

-- Release and disconnect the connectors -3- and -4- from the rear lid handle button.

Fig 1: Releasing And Disconnecting Connectors -3- And -4- From Rear Lid Handle Button

Courtesy of AUDI OF AMERICA, LLC

The Rear Peripheral Camera -R246- -1- is permanently attached to the handle button.

-- Remove the nuts -2- and -5-.

-- Pull the handle button with the Rear Peripheral Camera -R246- -1- out of the retainer in the rear lid.