Left Peripheral Camera - R244-/Right Peripheral Camera - R245-, Calibrating: Notes
Special tools and workshop equipment required
- Calibration Tool - VAS6350A-
- Peripheral Camera Calibration Device - VAS6350A/6-
- Vehicle Diagnostic Tester
The Left Peripheral Camera - R244-/Right Peripheral Camera -R245- are installed inside the left and right exterior mirrors.
The following describes calibrating the Left Peripheral Camera -R244-. Calibrating the Right Peripheral Camera - R245- is identical.
- Establish the requirements. Refer to Peripheral Camera System, Calibrating .
- Install and align the -VAS6350A- with - VAS6350A/6-. Refer to Calibration Tool VAS6350A with Peripheral Camera Calibration. .
- Connect the Vehicle Diagnostic Tester.
Setting Up the Calibration Device
-VAS6350/1- installing:
- Check the dimension of the holes.
- Equip the -VAS6350/1- appropriately. Use spacer pieces.
- To do so, secure the three wheel bolt adapters in the hole circle to each -VAS6350/1-.
- Place the paddle on both -VAS6350/1- and secure them using a clamping screw.
- Place the -VAS6350/1- onto the wheel bolts on the front wheels.
The -VAS6350/1- are positioned by the "O-rings" in the adapters and secured.
NOTE:
Attach the -VAS6350/1- onto the wheels so that any installed "anti-theft" wheel bolts are not connected to the - VAS6350/1-.
- Position the equipped -VAS6350A- with the -VAS6350A/6- -4- near the vehicle.
- Adjust the paddle -2- with a clamping screw so that it moves freely and easily just over the -VAS6350A- -4- calibration platform.