Rollover Support Function, Checking With Convertible Top Open

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2020 Audi S3, 2020 Audi RS 3, 2020 Audi A3 Quattro, 2020 Audi A3, and 2019 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.

Requirements:

The convertible top is opened.

Removal Procedures:

-- Remove both rollover protection trim pieces. Refer to the appropriate service information .

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Deselect "Working with Guided Fault Finding" by removing v and pressing Accept .

-- Switch to the "Special Functions" tab and select the following program:

15 - Rollover support output diagnostic test mode

-- Start the program using Perform test... .

-- Continue the program sequence.

Installation procedures occur in reverse order.