Additional Safety Precautions For Airbag Control Module

WARNING: This page is about a different car, the 2019 Audi S5 Sportback, 2019 Audi A5 Sportback, 2018 Audi S5 Sportback, and 2018 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

The "inertial sensor basic setting" must be performed after every removal and installation of the Airbag Control Module -J234-.
If the Airbag Control Module -J234- is replaced with a new part, the basic setting is performed when implementing the "15 - Replace airbag control module" program.
If the Airbag Control Module -J234- is removed and then the same one is reinstalled, perform the "inertial sensor basic setting" as follows:

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic operating mode.

-- Select the Test plan tab.

-- Select the Select individual test button and select the following tree structure consecutively:

Body
Body Assembly
01 - OBD-capable systems
15 - Airbag - Airbag Control Module -J234-
15 - Airbag, Functions
15 - Basic Setting
15 - Inertial Sensor Basic Setting

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.