Calibration System:VAS721001, INSTALLING AND ALIGNING: Notes

Special tools and workshop equipment required 

• Calibration System:VAS721001 
• Vehicle Diagnostic Tester

After performing service work on the vehicle, it may be necessary to calibrate the peripheral camera system. In detail, this is the case after:

• Replacing one or more cameras
• Peripheral Camera Control Module -J928- replacement
• Flash the software from the Peripheral Camera Control Module -J928-
• Record the data set on the Peripheral Camera Control Module -J928-
• Repair work on components in which a camera is installed or that influence the component location of the camera
• Wheel Alignments
• When adjusting the overlap range of the individual cameras
• The standing height of one axle changes by more than 5 mm
• The standing height of the entire vehicle changes by more than 10 mm