Installed Overview
The vehicle in the illustration is only a basic outline.
- :VAS6350/1
- :VAS6350/1
- Right Angle Bracket
- :VAS6350/2 mount
- Plastic Foot
- Three on underside of the calibration board
- Adjustable for aligning horizontal position of the calibration board
- :VAS6350/3
- On the calibration board
- Switching on and off. Refer to the Owner's Literature.
- :VAS6350/2
- On the calibration board
- Refer to the Owner's Literature for notes on the operation.
- Level
- On the calibration board
- For checking the horizontal position
- Left Angle Bracket
- :VAS6350/2 mount
- Calibration Board
- Between the mounts on the calibration board and the :VAS6350/1 -dimension A- 1.47 m through 1.90 m
Calibration Board Orientation
-- Position the calibration platform behind the vehicle at a distance of 1.47 m to 1.90 m to the rear wheels, see -dimension A- in the overview illustration. Refer to Installed Overview .
-- Bring the :VAS6350A into a horizontal position.
-- Twist the plastic feet under the calibration board so that the air bubble in the level is located exactly in the center of the indicator -arrow-.
Make sure light does not reflect off the calibration board.
Reflections impair the Rearview Camera -R189- and may make it impossible to perform the calibration.
The vehicle in the illustration is only a basic outline.
-- Switch on the :VAS6350/3 -1- on the calibration board and adjust the entire :VAS6350A so that the laser beam hits the center of vehicle rear above the Audi rings.
-- Check that the Audi rings are centered on the rear. Correct the laser beam accordingly.
Continue calibrating the Rearview Camera -R189-. Refer to Rearview Camera -R189-, CALIBRATING .