Overview - Control Module With Hydraulic Unit

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Audi SQ5, 2020 Audi Q5 e, 2020 Audi Q5, 2019 Audi SQ5, and 2019 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: ABS Hydraulic Unit With ABS Control Module Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

ABS Hydraulic Unit -N55- with ABS Control Module -J104-
- Component location: in the engine compartment.
- ABS Control Module -J104- WITH ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .
- The hydraulic control unit consists of ABS Hydraulic Unit -N55- with integrated Brake Pressure Sensor 1 -G201- and the ABS Control Module -J104-.
- Do not disconnect the connector before successfully completing OBD.
- Switch the ignition off before disconnecting the connector.
  NOTE:
  The hydraulic unit must not idle, otherwise this can lead to problems when bleeding the brake system.
  
  A new hydraulic unit is prefilled for the service with the brake fluid.
  
  All openings of the hydraulic unit must be closed when installing.
- Refer to NOTES FOR ABS Control Module -J104-
Bracket
- cannot be removed.
Connector
- For the ABS Control Module -J104-
- Refer to NOTES FOR ABS Control Module -J104-
Brake Line
- To the brake master cylinder
- Tightening Specification
Brake Line
- To the brake master cylinder
- Tightening Specification
Brake Lines
- Hydraulic Unit to Right Front Brake Caliper
- Hydraulic Unit to Left Front Brake Caliper
- Hydraulic Unit to Left Rear Brake Caliper
- Hydraulic Unit to Right Rear Brake Caliper
  WARNING:
  Do not bend the brake lines past their form or damage them.
  
  A bent or damaged brake line must be replaced.