Additional Safety Precautions For Airbag Control Module
WARNING: This page is about a different car, the 2022 Audi S4 and 2022 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- The "inertial sensor basic setting" must be performed after every removal and installation of the Airbag Control Module -J234-.
- If the Airbag Control Module -J234- is replaced with a new part, the basic setting is performed when implementing the "15 - Replace airbag control module" program.
- If the Airbag Control Module -J234- is removed and then the same one is reinstalled, perform the "inertial sensor basic setting" as follows:
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Body
- Body Assembly
- 01 - OBD-capable systems
- 15 - Airbag - Airbag Control Module -J234-
- 15 - Airbag, Functions
- 15 - Basic Setting
- 15 - Inertial Sensor Basic Setting
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.