FixVault

Overview - Sound System, Standard Sound System, 9VD

Standard Sound System without ANC, 9VD+EP0

Fig 1: 9VD - Audi Sound System Circuit Diagram
GWWA91-11196Courtesy of AUDI OF AMERICA, LLC
  1. Information Electronics Control Module 1 -J794- behind the glove compartment
  2. Left Front Treble Speaker -R20- /Right Front Treble Speaker -R22- on Left and Right Sides of Instrument Panel
  3. Left Front Bass Speaker -R21- /Right Front Bass Speaker -R23- in Front Doors
  4. Left Rear Treble Speaker -R14- /Right Rear Treble Speaker -R16- Inside the B-Pillars
  5. Left Rear Bass Speaker -R15- /Right Rear Bass Speaker -R17- in Rear Doors
  6. Center Speaker -R208- in the Center Instrument Panel
  7. Subwoofer -R211- in the rear shelf
  8. MOST Bus

Standard Sound System with ANC, 9VD+EP1

GWWA91-12744Courtesy of AUDI OF AMERICA, LLC
  1. Digital Sound System Control Module -J525- in luggage compartment on left rear side
  2. Left Front Treble Speaker -R20- in the instrument panel on the left side
  3. Left Front Door Speaker -RX2- in Left Front Door
  4. Left Front Midrange Speaker -R103- in Left Front Door
  5. Left Front Bass Speaker -R21- in Left Front Door
  6. Left Rear Treble Speaker -R14- in Left B-Pillar
  7. Left Rear Bass Speaker -R15- in Left Rear Door
  8. Center Speaker -R208- in the Center Instrument Panel
  9. Subwoofer -R211- in the rear shelf
  10. Right Rear Bass Speaker -R17- in Right Rear Door
  11. Right Rear Treble Speaker -R16- Inside Right B-Pillar
  12. Right Front Door Speaker -RX3- in Right Front Door
  13. Right Front Midrange Speaker -R104- in Right Front Door
  14. Right Front Bass Speaker -R23- in Right Front Door
  15. Right Front Treble Speaker -R22- in Instrument Panel on the Right Side
  16. Left Center Microphone -R142- /Right Center Microphone -R143- /Left Rear Microphone -R144- /Right Rear Microphone -R145-
  17. MOST Bus

Fault Finding is performed using the "Guided Fault Finding"  on the Vehicle Diagnostic Tester.

Notes on MOST bus

The optical data bus "MOST bus" is used in addition to the CAN bus.

A fiber-optic cable is used. Fiber optic cables are routed inside corrugated tubes for protection.

Replace the complete fiber-optic cable if possible.

The front surfaces of the connectors must not get dirty.

If disconnecting the connectors: Attach the Fiber-Optic Repair Set - Connector Protective Caps: VAS6223/9  .

Fig 2: Fiber-Optic Conductor Repair Set VAS 6223A
GWWW00-11495Courtesy of AUDI OF AMERICA, LLC

When routing fiber-optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink the fiber-optic cables.

Fiber-optic cable repair. Refer to FIBER-OPTIC CABLES, REPAIRING .