FixVault

Overview - Sound System, Basic Sound System (8RM)

The Basic Sound System consists of the following components:

Fig 1: 8 Speaker Circuit Diagram (8RM)
GWWA91-10016Courtesy of AUDI OF AMERICA, LLC
  1. Information Electronics Control Module 1 -J794- in the Rear Center Console
  2. Left Front Treble Speaker -R20- /Right Front Treble Speaker -R22- on Left and Right Sides of the Panel
  3. Left Front Bass Speaker -R21- /Right Front Bass Speaker -R23- in the Lower Front Doors
  4. Left Rear Treble Speaker -R14- /Right Rear Treble Speaker -R16- in the Rear Door Trim Panels
  5. Left Rear Bass Speaker -R15- /Right Rear Bass Speaker -R17- at Bottom of the Rear Doors
  6. MOST Bus

Fault Finding is performed using the "Guided Fault Finding" on the Vehicle Diagnostic Tester.

Notes on MOST bus

The optical data bus "MOST bus" is used in addition to the CAN bus.

A fiber-optic cable is used. Fiber optic cables are routed inside corrugated tubes for protection.

Replace the complete fiber-optic cable if possible.

The front surfaces of the connectors must not get dirty.

If the connectors are disconnected: connect the Fiber-Optic Repair Set - Connector Protective Caps:VAS6223/9  from the Fiber-Optic Repair Set:VAS6223A  .

Fig 2: Fiber-Optic Conductor Repair Set VAS 6223A
GWWW00-11495Courtesy of AUDI OF AMERICA, LLC

When routing fiber-optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink the fiber-optic cables.

Fiber-optic cable repair. Refer to FIBER-OPTIC CABLES, REPAIRING .