Control Module/Digital Sound System Amplifier, Removing And Installing, SPORTBACK: Removing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Loosen the back of the right luggage compartment side trim panel until the Digital Sound System Control Module -J525- is accessible. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Release and disconnect the connector -2- from the Digital Sound System Control Module -J525-.

Courtesy of AUDI OF AMERICA, LLC

-- If installed, release and disconnect the connectors -3- at the Parking Heater Radio Receiver -R64-.

-- If installed, release and disconnect the connectors -4- at the Peripheral Camera Control Module -J928-.

-- Release the retainers -arrows- from the bracket -1-.

-- Remove the bracket -1- with the control modules from the body and also the pin.

-- Release the retainers -arrows- from the bracket -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Digital Sound System Control Module -J525- -2- out of the bracket -1-.