Windshield Projection Head Up Display Control Module, Removing And Installing: Installing

WARNING: This page is about a different car, the 2023 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

CAUTION:

There is a risk of destroying the windshield projection head up display control module.

- A control module that has fallen down cannot be used again.

- When inserting the control module, never apply pressure on the housing upper section.

-- Check the control module function.

Conditions

A number must be visible on the windshield.

If the Windshield Projection Head Up Display Control Module -J898- was replaced, then complete the test plan for replacing the control module.

-- Complete the "control module, replacing" function using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .

Continuation