Driver Assistance Systems Front Camera, Calibrating, Dynamic Calibration (Calibration Drive)

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Calibrating the front camera is necessary:

The installation position of the Driver Assistance Systems Front Camera -R242- in the vehicle has changed.
Rear axle toe/chamber was adjusted.

Special tools and workshop equipment required

Vehicle Diagnostic Tester

Calibration Conditions

DTC memory is without relevant entry.

Procedure

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic operating mode.

-- Select the Test plan tab.

-- Select the Select individual test button and select the following tree structure consecutively:

Diagnostic-capable systems
00A5 - Driver Assistance Systems Front Camera - R242
00A5 - Driver Assistance Systems Front Camera - R242, Functions
00A5 - Calibration

-- Start the selected program and follow the instructions on the display of the Vehicle Diagnostic Tester by running a short calibration run.

Dynamic calibration of several driver assistance systems.

The front camera and the other driver assistance systems can alternatively be calibrated together during the calibration run, to do so, select the following tree structure:

Diagnostic-capable systems
00A5 - Driver Assistance Systems Front Camera - R242
00A5 - Driver Assistance Systems Front Camera - R242, Functions
00A5 - Dynamic Calibration of several Driver Assistance Systems

-- Start the selected program and follow the instructions on the display of the Vehicle Diagnostic Tester by running a short calibration run.