Contoured Surface: Notes
The edges and recesses on a contoured surface conform to specific dimensions.
If any surfaces or parts that have been worked on, such as removing dents, welding or spackling, must be dry sanded with minimum P 80 grit sandpaper.
The vehicle paint shop technician must then re-create the respective surface in a maximum of two steps.
CAUTION:
Leaded soldering tin may not be used since 01/01/2003. Audi AG has not approved any unleaded soldering tin procedure.
- To create the contoured surface on the steel panel use the Two-Part Metal Spackling Set:D 787 300 A2 .
- To create the contoured surface on the aluminum panels use the Aluminum Powder:DA 004 200 A2 and the Hardener:DA 004 201 A1 .