Hydraulic System Bleeding

Make sure master cylinder is full of fluid, and that slave cylinder bleeder screw is at uppermost position. Attach a rubber hose to bleeder screw, then immerse other end of hose in a translucent container of brake fluid.
Open bleeder screw approximately 3/4 turn, depress clutch pedal to end of its travel, then close bleeder screw before allowing pedal to return to normal position. Continue procedure until fluid delivered into container is free of air bubbles.
NOTE: Make sure that master cylinder fluid level does not fall so low as to allow air to enter system.

Refill master cylinder to level mark on reservoir.