Hydraulic Bleeding
- Fill fluid reservoir.
- Attach bleeder hose to slave cylinder bleed screw. Submerge the free end of hose into a container part full with brake fluid.
- Pump clutch pedal about 10 times. Hold pedal down on last pump stroke.
- Loosen bleed screw and allow air to escape.
- Close bleed screw.
- Repeat steps 3- 5 until all air is bled from clutch hydraulic system.
TIGHTENING SPECIFICATIONS
| Application | Ft. Lbs. (mkg) | ||
|---|---|---|---|
| Clutch-to-Flywheel | 16-17 (2.2-2.4) | ||
| Master Cylinder Mounting Bolt | |||
| Except 733i | 16-17 (2.2-2.4) | ||
| Except 530i and 733i | 18-20 (2.5-2.8) | ||
| Clutch Housing-to-Engine | |||
| 530i | |||
| 8 mm Bolts | 16-17 (2.2-2.4) | ||
| 10 mm Bolts | 31-35 (4.3-4.8) | ||
| 320i, 633CSi, 733i | |||
| 8 mm Bolts | 18-19 (2.5-2.7) | ||
| 10 mm Bolts | 34-37 (4.7-5.1) | ||
| Transmission-to-Clutch Housing | |||
| 633CSi | 52-57 (7.2-8.0) | ||
| 733i | 54-59 (7.5-8.2) | ||