Removal & Installation
- Before proceeding further, follow the air bag service precautions. Refer to SERVICE PRECAUTIONS . Disable the SRS. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
- Using Torx TX30 bit with long shank, remove Torx screws from rear of steering wheel. Lift off air bag module enough to unplug wiring connector from rear of module. Place module away from work area (in trunk), with pad facing upward.
- To install, reverse removal procedure. Tighten Torx screws to 70 INCH lbs. (8 N.m). Activate SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM . Perform system operation check to ensure system is functioning properly. See SYSTEM OPERATION CHECK .