FixVault

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Camshaft Flange Nut 101-108 (137-147)
Connecting Rod Bolts 38-42 (52-57)
Cooling Fan Nut (1) 22 (30)
Cylinder Head Bolts (2)
Exhaust Manifold Bolts 16-18 (22-24)
Exhaust Pipe Flange (3-Hole) 14-17 (19-23)
Flywheel Bolts (3) 83-96 (113-130)
Front/Rear Crankshaft End Cover Bolts (8 mm) 16 (22)
Intake Manifold Bolts 16-18 (22-24)
Main Bearing Cap Bolts (4) 43-46 (58-62)
Oil Pan Cover Bolts (8 mm) 15 (20)
Oil Pump Bolts 15-18 (20-24)
Oil Pump Sprocket Nut 19-22 (25-30)
Timing Chain Tensioner Plug 22-29 (30-40)
Upper/Lower Timing Case Cover Bolts (8 mm) 16 (22)
Vibration Damper Bolts 17 (23)
Vibration Damper Hub Bolt 317-332 (430-450)
Water Pump Bolts (8 mm) 16 (22)
INCH Lbs. (N.m) 
Camshaft Oil Pipe Bolt (Hollow) 97-114 (11-13)
Camshaft Sprocket Bolts 62 (7)
Cylinder Head Cover Bolts 79 (9)
Front/Rear Crankshaft End Cover Bolts (6 mm) 79 (9)
Rocker Arm Bolts 79-97 (9-11)
Oil Pan Cover Bolts (6 mm) 79 (9)
Oil Pump Cover Bolts 79 (9)
Oil Pump Sprocket Bolts 71-89 (8-10)
Thermostat Housing Bolts 79 (9)
Upper/Lower Timing Case Cover Bolts (6 mm) 79 (9)
Water Pump Bolts (6 mm) 79 (9)
Water Pump Pulley Bolts 79 (9)
(1) Using 32-mm Wrench (11-5-040). If using a conventional 32-mm wrench, tighten nut to 29 ft. lbs. (40 N.m).
(2) Tighten bolts in 4 steps and in sequence. See Figure. Step 1) Tighten to 43-46 ft. lbs. (58-62 N.m). Step 2) Wait 20 minutes. Step 3) Tighten to 58-60 ft. lbs. (78-82 N.m). Step 4) Run engine at operating temperature for 25 minutes, and tighten bolts to 30-40 degrees.
(3) Replace bolts, and apply locking compound to threads.
(4) Use clean, lightly oiled bolts.