Steering Lock: Installation

1. To install, reverse removal procedure. Dowel pin must fit in bore. See Fig 1 .
2. Tighten Torx screws until they shear off. See Figure .
3. Fit bush (2). Fit snap ring (1) with special tool (32 1 090) and steering wheel retaining screw until it engages in groove of steering spindle. Snap ring (1) can also be mounted using special tool (32 3 070). See Fig 2 .
4. Lock headless screws with varnish.
5. Guide both holders of upper section into bores. See Fig 3 .
6. Check for correct position of lock. On 318ti, use new shear-off screws. On all models see Fig 4 .
7. Check position of collar relative to snap ring. Recess in collar locks snap ring. See Figure .
8. Test lock cylinder and electric operation (e.g. ignition, radio, etc.).

Fig 1: Fitting Dowel Pin In Bore

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Mounting Snap Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 3: Locating Upper Section Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 4: Pulling Apart Steering Column Sections

Courtesy of BMW OF NORTH AMERICA, INC.