Leak Diagnosis Test Preconditions

The ECM only initiates a leak diagnosis test every second time the criteria are met. The criteria is as follows:

• Engine OFF  with ignition switched OFF. 
• Engine Control Module still in active state or what is known as "follow up mode" (Main Relay energized, control module and ECM components online for extended period after key off).
• Prior to Engine/Ignition switch OFF condition, vehicle must have been driven for a minimum of 20 minutes.
• Prior to minimum 20 minute drive, the vehicle must have been OFF for a minimum of 5 hours.
• Fuel Tank Capacity must be between 15 and 85%  (safe approximation between 1/4 - 3/4 of a tank).
• Ambient Air Temperature between -7°C & 35°C  (20°F & 95°F)
• Altitude < 2500m  (8,202 feet).
• Battery Voltage between 11.5 and 14.5 Volts 

When these criteria are satisfied every second time, the ECM will start the Fuel System Leak Diagnosis Test. The test will typically be carried out once a day ie:, once after driving to work in the morning, when driving home in the evening, the criteria are once again met but the test is not initiated. The following morning, the test will run again.