Window Initialization Procedure (61 10 02)
Publication date: 2002-10-01Reference number: 61 10 02
WINDOW INITIALIZATION PROCEDURE
TECHNICAL SERVICE BULLETIN
Reference Number(s): SI B61 10 02, Date of Issue:
October 2002
| BMW: | E65, E66 (7 Series) |
| GROUP: | 61 - General Electrical Systems |
SUBJECT
Window Initialization Procedure
SITUATION
After replacement of a door module the window only moves in small increments and does not have toll functions.
CAUSE
Window needs to be initialized.
PROCEDURE
- After door module has been installed, program/code as per SI B09 05 01 .
- Make sure that window to be initialized is in the full open position.
- Close the door of the window that needs to be initialized.
- Press and hold the window switch all the way down for approximately 17 seconds.
- Lift switch and hold up.
- Window will move up through its full travel, then down and back up again.
- Test function of toll feature.
WARRANTY INFORMATION
For information only.