FixVault

Initialization Of Power Windows

INITIALIZATION OF POWER WINDOWS

Front Windows Rear Windows
On Initial start-up, only the upper window stop has to be learned. For this purpose the window must be held for 500 ms at the upper stop position.
A characteristic curve in not learned for the front windows. The lower stop does not have to be approached. In order to compensate for mechanical aging, an automatic readjustment of the end position is performed cyclically at the upper stop.
Move window to full closed position and hold for at least 500 ms. 
The rear windows must be initialized.
During the initialization the end positions of the window travel are determined by limit runs into the upper window seal and to the lower window stop.
Move window to full closed position and hold for at least 500 ms. 
Move window to lower window stop and hold for 17 seconds. 
Move window to full closed and continue to hold the switch in the window closing direction. 
The Window will open the close to confirm proper initialization. 
NOTE: This procedure is the same as E65.