86 10 ... Removing Rear Supports and Bracket

Release screws (1) and remove rear support (2) from bracket (3).

Installation:

Tightening Torque: 86 10 26AZ, see 86 10 PLATFORM .

Fig 1: Identifying Screws, Rear Support & Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable holders (1) from bracket (2). Release screws (3) on left and right sides of bracket (2). Drill out rivets (4) from underside of platform. Drill out rivets (5) from upper side of platform.

Installation:

Tightening Torque: 86 10 27AZ, see 86 10 PLATFORM .

Fig 2: Identifying Cable Holders, Bracket, Screws & Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed cable for rear light (1) through opening (2). Fit cable holders (4) in holes (3).

Fig 3: Identifying Screw & Tilt Shock Absorber

Courtesy of BMW OF NORTH AMERICA, INC.