6131009 Repairing steering column switch cluster (SZL): Installation
IMPORTANT:
Thoroughly clean your hands before installation.
Before installing the new parts, put on gloves and hair net included in the repair kit!
Before installing the new parts, put on gloves and hair net included in the repair kit!
IMPORTANT:
Not permitted!
- Do not touch encoded disc (1) with your fingers!
- Do not touch printed circuit board (2)!
- Do not apply pressure to encoded disc (3)!
- Do not touch sides of encoded disc (4)!
- Hold encoded disc (1) by inserting two fingers in the hole.
- Position encoded disc centered in fixture and clip it in.
- Turn encoded disc to and fro to spread the grease over the friction face
Assembly optical element (1) from individual parts included in the repair kit.
- Secure optical element (2) with screws (1).
- Tightening torque: 0.26 Nm.
- Clip upper housing section (1) into place.
- After inserting coil spring cassette, affix "CDS" label close to part-number label (2).
Installation note:
Make sure retaining lugs are correctly engaged.
Installation note:
Mark (1) and mark (2) must point to each other.
Carry out STEERING ANGLE SENSOR ADJUSTMENT .
Carry out VEHICLE PROGRAMMING/ENCODING .