Top Rear View Control Unit Functions Intermittently (66 06 10)

Publication date: 2010-10-05
Reference number: 66 06 10

TOP REAR VIEW CONTROL UNIT FUNCTIONS INTERMITTENTLY

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI B66 06 10, Date of Issue: October 2010

BMW:	E70 (X5); E71, E72 (X6); Vehicles produced from 9/30/09 up to 9/29/10
GROUP:	Distance Systems, Cruise Control, Remote Control

Superceded Bulletin(s): SI B66 06 10, Date of Issue: September 2010

NOTE: This Service Information bulletin supersedes SI B66 06 10 dated September 2010.

SUBJECT

Top Rear View Control Unit Functions Intermittently

SITUATION

The top rear view control unit (TRSVC) functions intermittently. After deleting the fault memory in the TRSVC control unit, there is a possibility that the original fault entries may reappear in the control unit after the next restart. This may occur with every fault stored in the TRSVC control unit.

CAUSE

Software fault in the TRSVC control unit.

PROCEDURE

Do not replace any parts!

Program and code the vehicle using ISTA/P 2.39.0 or higher.
Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.
For information on programming and coding with ISTA/P, refer to CenterNet / Aftersales Portal / Service / Workshop Technology / Vehicle Programming.

WARRANTY INFORMATION

Covered under the terms of the BMW New Vehicle Limited Warranty.

Defect Code: 66 53 04 02 00

WARRANTY INFORMATION

Labor Operation:	Labor Allowance:	Description:
00 00 006*	Refer to KSD2	Perform vehicle test
61 00 710	Refer to KSD2	Program and Code with ISTA/P (w/o CAS)
61 00 720	Refer to KSD2	Program and Code with ISTA/P (with CAS)
Refer to KSD2	Refer to KSD2	Concluding work (initializations) as described in ISTA/P final report

*Main Work - Only one main labor operation (ending with 000-499) may appear on any claim or group of claims (warranty, maintenance or campaigns) that are generated from the same repair visit.

All other labor operations on the same line or other lines must be claimed using plus code labor operations (KSD2 labor operations that have a (+) prefix and the last three digits are 500 or a higher number).

In cases where ISTA requires the replacement of control modules or additional programming because certain control modules failed to program correctly, or just an initialization is required, print out the Measures Plan and/or Final Report and attach these reports to the RO in the vehicle file. This additional work should be claimed under the defect code listed in this bulletin, using the labor operation and labor allowance from the KSD2.