Control Arm: Remove & Replace
WARNING: This page is about the Z4 28i, Automatic Trans, which is a different variant/trim than selected.
DOES NOT include alignment.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All | 3.6 | B | ||
| Both Arms,Left Side | 2.4 | B | ||
| Both Arms,Right Side | 1.9 | B | ||
| Lower,Both | 2.2 | B | ||
| Lower,Left Side | 1.5 | B | ||
| Lower,Right Side | 1.0 | B | ||
| Upper,Both | 3.2 | B | ||
| Upper,Left Side | 2.2 | B | ||
| Upper,Right Side | 1.7 | B | ||
| Combination Procedure: BALL JOINT: Replace: | ||||
| Bushing Type,Each | 0.4 | B | ||
| Combination Procedure: CONTROL ARM BUSHING: Replace: | ||||
| Each | 0.4 | B | ||