Check Control Message: No Oil Pressure (12 18 16)
Publication date: 2016-09-01Reference number: 12 18 16
CHECK CONTROL MESSAGE: NO OIL PRESSURE
TECHNICAL SERVICE BULLETIN
| BMW: | F25 (X3 xDrive 28d); F30 (3 Series Sedan 328d); F31 (3 Series Sport Wagon 328d); F10 (5 Series Sedan 535d); F15 (X5 3.5d); F02 (7 Series Sedan 740dl) With the N47T and N57T diesel engine |
| GROUP: | Engine Electrical Systems |
SITUATION
Check Control message: Oil pressure warning. Stop carefully is displayed. There are no related faults to oil pressure stored in the DDE.
CAUSE
Unfavorable DDE software application
When operating during automatic engine start-stop function stop, it may be the case that the oil pressure is incorrectly determined to be too low, which triggers a CC message.
CORRECTION
Reprogram vehicle.
PROCEDURE
- Perform diagnosis with the latest version of ISTA.
- Program the vehicle using ISTA/P 3.56.0 or higher.
| Models | Integration Level |
|---|---|
| F25 (X3 xDrive 28d) | 15-07-500 |
| F30 (3 Series Sedan 328d) | |
| F31 (3 Series Sport Wagon 328d) | |
| F10 (5 Series Sedan 535d) | |
| F15 (X5 3.5d) | |
| F02 (7 Series Sedan 740dl) |
Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.
Always connect a BMW approved battery charger/power supply (SI B 04 23 10 ).
For information on programming and coding with ISTA/P, refer to Centernet / Aftersales Portal / Service / Workshop Technology / Vehicle Programming.
WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle Limited Warranty for Passenger Cars and Light Trucks or the BMW Certified Pre-Owned Program.
| Defect Code: | 12 61 01 14 00 |
| Labor Operation: | Labor Allowance: | Description: |
|---|---|---|
| 00 00 006 | Refer to KSD2 | Performing "vehicle test" (with vehicle diagnosis system - checking faults) |
| And: | ||
| 61 21 528 | Refer to KSD2 | Connect an approved battery charger/power supply (indicated in KSD2 as "Charging battery") |
| And: | ||
| 61 00 730 | Refer to KSD2 | Programming / encoding control unit(s) |
If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead.
Refer to KSD2 for the corresponding flat rate unit (FRU) allowances.
Vehicle Programming and Coding
Control module failures that occur during programming:
- Please claim these consequential repairs under the defect code listed in this bulletin and use the applicable KSD2 labor operations.
Other Repairs
Control module failures that occur prior to programming and/or additional work is performed as a result of performing the ISTA diagnostics and related test plans:
- When covered under an applicable limited warranty, claim these repairs using the applicable defect code and labor operations in KSD2.