General Orphan Data (1 Of 4)
- (Removing the cylinder head cover)
- (Removing the VANOS central valve of the exhaust camshaft adjuster)
- (Removing the oil return line in the cylinder head)
- (Removing rear timing case cover)
- (Refitting sump)
- (Adjusting the camshafts with the special tool)
- (Installing the VANOS central valve of the exhaust camshaft adjuster)
- (Remove all special tools)
- (Installing cylinder head cover)
- (Installing the high-pressure rail with injectors of the cylinders 4 to 6)
- (Installing all spark plugs)
- (Installing the coolant feed line part 2 between the auxiliary coolant pump and exhaust turbocharger)
- (Installing the connecting bracket on the exhaust turbocharger for cylinders 4 to 6)
- (Installing the clean air pipe for cylinders 4-6)
- (Removing the intake plenum)
- (Remove bearing bracket)
- (Install all roller cam followers)
- (Version with eccentric shaft servomotor: Teaching in the end stops with the diagnostic system)
- (Adjusting the eccentric shaft to minimum lift)
- (Remove torsion springs)
- (Checking the position of the intake camshaft)
- (Check the position of the intake camshaft at cylinder 3 and 4)
- (Installing torsion springs)
- (Removing the complete front axle with the engine and transmission)
- (Removing the catalytic converters for the cylinders 1 to 6 (engine removed))
- (Installing catalytic converters for cylinders 1 to 6 (engine removed))
- (Installing the complete front axle with the engine and transmission)
- (Remove tank vent valve)
- (Installing the intake plenum)
- (Removing the DME control unit)
- (Removing the integrated supply module (PDM) partially)
- (Removing the control unit holder)
- (Partially releasing the engine oil cooler)
- (Connect the coolant lines for the low-temperature coolant circuit)
- (Removing suspension strut brace)
- (Removing upper cross connection)
- (Securing the engine oil cooler)
- (Partially installing the integrated power supply module (PDM))
- (Installing the DME control unit)
- (Installing the cover for the DME control unit)
- (Venting the low-temperature cooling system)
- (Installing bottom front cover from the side)
- (Removing the right intake port)
- (For electrical wastegate valve controller: Teaching in and checking end stops with the diagnostic system (after vehicle diagnosis))
- (Installing the right intake port)
- (Install the strut brace)
- (Install the front hood seal)
- (If the DME control unit is replaced: Program/code DME control unit)
- (When replacing the alternator/alternator regulator: Reset generator statistical data)
- (Removing transmission bearing support)
- (Remove transmission mounting bracket (all-wheel drive vehicle))
- (Install transmission mounting bracket (all-wheel drive vehicle))
- (Installing the transmission bearing support)
- (Reset ultra-small quantity adaptation)
- (Removing front heat shield)
- (Replacement: Adjusting the exhaust gas pressure sensor)
- (Installing front heat shield)
- (Install charge air cooler)
- (Removing the front bottom side cover)
- (Removing the right hand front bottom side cover)
- (Removing the cover for the DME control unit)
- (Drain the coolant from the low-temperature cooling system)
- (Remove charge air cooler)
- (Installing the control unit holder)
- (Fill and vent the low-temperature coolant circuit)
- (Installing the left and right front undershield)
- (Removing the air ducts in the dashboard)
- (Installing the air ducts in the dashboard)
- (Preparing the special tool)
- (Removing the right air duct)
- (Installing the right air duct)