Speed Control Switch: Installation

Use guide wire to install wire harness through steering column. Reconnect wiring harness connector. Position turn signal lever into place and secure with screw. To complete installation, reverse removal procedure.

Install brush assembly and steering wheel. Insert 2 screws from back of steering wheel into switch assembly. Insert electrical connector. To complete installation, reverse removal procedure.

Connect switch harness to follower wire and pull harness into column. Position turn signal lever on switch and install screw. To complete installation, reverse removal procedure.

Connect new wiring harness to follower wire. Pull harness into column and reconnect shift lever. To complete installation, reverse removal procedure.

Connect new harness to follower wire. Pull harness into column. Align key on turn signal lever with slot in turn signal switch. Push lever in until seated in snap lock. To complete installation, reverse removal procedure.